REPAIR AND REPLACEMENT PROCEDURES MODULE REPLACEMENT WBPEEUI350001B0 7 - 5 14. Refer to the INFI-NET Ethernet Server Installation and Configuration instruction to load the system software, and configure the hard disk drive and Ethernet server. Upon power up (or reset, the Ethernet server module should startup automatically. INSCS01 Module Replacement There are no active components on the SCSI module to fail. Therefore, it is highly unlikely that this module is the cause of a failure. If the SCSI module is suspected of having a short or open in a trace or connection, use an ohmmeter to check the minifuse on the SCSI adapter board mounted on the INESM01 module. If the SCSI adapter board fuse is open, call service for fuse replacement. If the SCSI adapter board fuse is good, replace the INSCS01 module and ribbon cable. The INSCS01 module bridges the INESM01 and IMMPI01 modules. The INESM01 module must be shutdown before disconnecting the INSCS01 ribbon cables. Failure to properly shutdown the INESM01 module could result in file corruption. To replace the module. Refer to
