Ensure that the location meets the network requirements:•

Preinstallation
23
Phone E without these servers in MCS 5100 Release, but Nortel recommends using these servers to aid in the deployment and configuration of the IP Phone E with SIP
Firmware. Using DHCP and DNS servers with CS 2000 network is recommended but not mandatory.
•
An Ethernet connection to a network with an appropriate SIP
proxy server.
•
One of the following file servers used as a Provisioning server TFTP server FTP server HTTP server
Only a TFTP server can be used for an initial UNIStim-to-SIP
Firmware conversion. An IP Phone E with SIP Firmware can operate with a TFTP, FTP, or HTTP file server.
—End—
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

24
Before installation
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

25
Configure the provisioning server
ATTENTION
If you have UNIStim Firmware on your IP Phone E, the firmware must be converted from UNIStim to SIP before you proceed with the following instructions.
See the chapter "Upgrade and convert the IP Phone E firmware" (page
67)
for instructions on how to convert the firmware on an IP Phone E from
UNIStim to SIP.
If the IP Phone E is installed with SIP Firmware, further SIP Firmware upgrades can be done with a TFTP, an FTP, or an HTTP server.

Download 1.47 Mb.

Share with your friends: