Sip firmware Release 1 for ip phone 1140e administration

84
Device Settings on the IP Phone E with SIP Firmware
•
Gateway
•
DNS IP
•
Provisioning server IP, protocol, and, if user authentication is required to access the provisioning server, the user credentials
Note: TFTP protocol does not require user authentication. Device ID
and password are ignored. FTP protocol requires user authentication and the default Device ID is anonymous with no password.
HTTP protocol can operate with or without user authentication. If no authentication is required, make sure to clear the Device ID and password fields in the configuration dialogue.
SET IP
Select SET IP in the Device Settings menu to configure the IP address.
Net Mask
Enter a subnet mask In the Net Mask field.
Gateway
Enter an IP address of the local gateway in the Gateway field.
DNS IP
Configure the Domain Name Server (DNS) IP.
Voice VLAN
Configure the Voice VLAN.
Table 16
Telephony Port (incoming)
Voice VLAN Setting
Result
No (default setting)
All telephony traffic that is transmitted on the telephony port is forwarded untagged
Auto (Not available if DHCP is set to No)
Enable Automatic VLAN Discovery for Voice
VLAN. Initial DHCP request is forwarded based on the Data VLAN policy (for example, untagged if Data VLAN is disabled, or tagged with the
Data VLAN ID if Data VLAN is enabled) to obtain
Voice VLAN IDs. Subsequent DHCP requests using the acquired Voice VLAN IDs and the resolution of a Voice VLAN determine the final
Voice VLAN ID used for signaling and the media traffic on the telephony port. Note This means that if a Data VLAN ID is configured in the IP
Phone E and the Voice VLAN is set to Auto
(Automatic Voice VLAN Discovery, the DHCP
server to provide Voice VLAN information must
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

Introduction
85
be on the Data VLAN. If the DHCP server is not on the Data VLAN, the IP Phone E fails to receive the DHCP information and fails to register. In addition, another DHCP server must reside in the Voice VLAN to provide the network parameters required. For more information, seethe section on DHCP Auto VLAN Discovery.
4095
All telephony traffic that is transmitted on the telephony port has an q header appended and its Voice VLAN ID is set to the value manually configured here. Place the cursor over the 4095 and press the enter NAV key to modify this value to the desired Voice VLAN tag. Note that the value 4095 is not a valid VLAN ID. This is intentional to ensure a proper VLAN ID is entered.

Download 1.47 Mb.

Share with your friends: