(COMPUTER APPLICATIONS FOR ME)
PLATE 1
MODULE-2
Name:
|
Professor:
|
Section:
|
Date Submitted:
|
INSTRUCTION: Answer the following questions.
Follow the instructions in Module 1. In this plate you will create the part shown below.
Task 1 — Converting Dimensions
The design for this part was created in Europe. It will be manufactured in the US. Convert the overall dimensions of from millimeters to inches. Create this model in SolidWorks and save the part named as [SURNAME]-TASK1.sldprt (Example: OMLANG-TASK1.sldprt) in the submission drive.
Given:
Conversion: 25.4 mm = 1 inch
Base width = 120 mm
Base height = 120 mm
Base depth = 50 mm
Boss depth = 25 mm
Hole Outside diameter = 60 mm
Hole inside diameter = 50 mm
Big fillet = 10 mm
Medium fillet = 5 mm
Small fillet (edges of hole) = 1 mm
Task 2 — Calculating the Modification
The current overall depth of this part is 75 mm. Your customer requires a design change. The new required overall depth is 100 mm. The Base depth must remain fixed at 50 mm. Create this model in SolidWorks and save the part named as [SURNAME]-TASK2.sldprt (Example: OMLANG-TASK2.sldprt) in the submission drive.
Given:
New overall depth = 100 mm
Base depth = 50 mm
Task 3 — Calculating Material Volume
Material volume is an important calculation for designing and manufacturing parts. Calculate the volume of the model in task 2 in mm3. Provide a screenshot of the calculated volume from SolidWorks and save it in the submission drive.
Share with your friends: | 
