Procedia Chemistry 10 ( 2014 ) 448 – 453 1876-6196 © 2014 The Authors. Published by Elsevier B.V. This is an open access article
under the CC BY-NC-ND license (
http://creativecommons.org/licenses/by-nc-nd/3.0/
).
Peer-review under responsibility of Tomsk Polytechnic University doi: 10.1016/j.proche.2014.10.075
ScienceDirectXV International Scientific Conference Chemistry and Chemical Engineering in XXI century dedicated to Professor LP. Kulyov Modelling of dewatering and desalting processes for large-capacity oil treatment technology SF. Kim a, NV. Usheva a, OE. Moyzes a, EA. Kuzmenko a, MA. Samborskaya a, EA.
Novoseltseva a
aNational Research Tomsk Polytechnic University, Lenin av, 30, 634050, Tomsk, Russian Federation Abstract This paper is devoted to analysis of oil treatment technology in the case of complex industrial process realization and further selection of technological mode. Mathematical modelling method is used to improve the efficiency of dewatering and desalting processes. The simulation system based on module modelling principle is developed. Every module is described in terms of appropriate combination of phenomena and processes. Problems of oil treatment analysis of complex structured technological scheme and searching of effective dewatering and desalting processes technological modes are solved.
© 2014 The Authors. Published by Elsevier B.V.
Peer-review under responsibility of Tomsk Polytechnic University.
Keywords: Mathematical modelling
Oil treatment plant Dewatering; Desalting