Collocation application
DC POWER REQUIREMENTS – Initial applications and augments to increase power to an existing arrangement
Download 498.59 Kb.
|
- Navigate this page:
- DC POWER REQUIREMENTS – AUGMENTING POWER Please indicate below the type of feed request. [__] Request for a new
- Termination
- Power Configuration Feed * Disposition
- Amps Fused Existing Amp Fused Requested Cable Ampacity
- BDFB/MPB/RR Designation Panel Designation
DC POWER REQUIREMENTS – Initial applications and augments to increase power to an existing arrangement.General Instructions The CLEC is responsible to engineer the power consumption required at the collocation arrangement and is responsible for taking into consideration any special circumstances in determining the drain/load and fuse size of the feed. Please indicate your requirements for –48V Battery & Ground. Provide the total number of “A” feeds and/or the total number of “B” feeds for each type of collocation request. Indicate the requested drain/load per feed and the fuse size per feed. Where applicable, include ampacity and cable designation information as well. Fused capacity shall not exceed 2.5 times the CLEC specified load per feed, except in NY & CT where the CLEC can request fused capacity not to exceed 4 times the CLEC specified load per feed. Drain/load per feed must be expressed in whole numbers and not fractions. Additionally, fuses must be ordered in industry standard sizes referenced in the application instructions. 8 APP-001-082202-08.doc Re-Issued: 09/11/08 When ordering multiple power feeds, please indicate each feed’s requirement separately. Refer to the application instructions for specifications on industry standard sizing. Fusing at 2.5 times load (4 times in NY & CT) may not be possible in all cases based on the CLEC specified load. In those situations, the CLEC must determine whether to choose a fuse size that is less than 2.5 times load (4 times load in NY & CT) or increase its load in order to conform to the industry fuse sizes. Note: Requests to decrease either fuse or load requirements on an existing feed must be submitted via a Notice of Termination/Reduction application. DC POWER REQUIREMENTS – AUGMENTING POWER Please indicate below the type of feed request. [__] Request for a new feed (use Disposition Code: N in table) [__] Make a change to an existing feed to a larger capacity feed (use Disposition Code: C in table) [__] Load/Drain increase on an existing feed [__] Fuse increase on an existing feed [__] Termination of a feed that is being replaced by an N coded larger ampacity feed. (use Disposition Code: T) Joint coordination may be required to identify applicable power feeds. Verizon must approve all drain/load or fusing changes to existing power cables. Please note all applicable tariff/interconnection agreement rates and augment intervals will apply for an increase in fuse or drain size that requires new cabling.
Re-Issued: 09/11/08 Detailed Power Requirements
*Disposition: please indicate using codes in section V.2. A. Directory: wholesale -> attachments -> collocation collocation -> Collocation Remote Terminal Equipment Enclosure (crtee) Application collocation -> Instructions For use in the former Bell Atlantic and nynex regions collocation -> Feeder Distribution Interface Interconnection Application Instructions attachments -> Verizon Communications Operations in Virginia attachments -> Title or degree abbreviation attachments -> Actl job Aid actl – Access Customer Terminal Location collocation -> Partner Solutions Collocation Application Instructions Prior to submitting an initial Collocation Application, the customer must initiate the account establishment process. Please contact an Account Manager for details Download 498.59 Kb. Share with your friends:
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||