In this scenario the bridge is created between eth0 and eth2 interfaces, while the third interface eth1 is used for the separate network.
It is possible to set up the bandwidth upload and download limits on the WAN eth0 interface. The PBX reserves the bandwidth needed for the communication with VoIP operators and remote phones. The priority is given to the traffic generated on the LAN eth1 port.
Connect the second Switch to the LAN2 port of the PBX
Click “Enable traffic shaper eth0-eth2”
Click “Apply the network settings”
The bridge between WAN eth0 and LAN eth2 interfaces is created, leaving a separate network to the remaining LAN eth0 interface.
The interfaces eth0 and eth2 are no longer present on the page, the interface wbr0 is used as WAN which maintains the same settings of the eth0 interface (either static IP or DHCP client.
Select the WAN wbr0 interface and set up the bandwidth limits for Downlink and Uplink, to reserve this bandwidth for the communication with VoIP operators and remote phones:
LAN eth1 interface settings:
Click “Apply the network settings”
The IP address assigned to the PBX could change. Check the address of WAN wbr0 interface to know the correct IP address of the PBX.
Share with your friends: |
