O’Connor Name ato 2200 Brake Systems
Download 11.8 Kb.
|
- Navigate this page:
- Guidelines for Anti-Lock Brakes Report
|
O’Connor Name________________ ATO 2200 - Brake Systems EVALUATION1. Typing & spelling 10 points _________ 2. Content (Did what was required?) 37 points _________ 3. Bibliography/Sources 3 points _________ Total __________ /50 Guidelines for Anti-Lock Brakes ReportA. Due Date November 29, 2011. This assignment will not be accepted late! B. Directions: Use your lecture notes, service manuals, Alldata, Mitchell On-Demand, videotapes, textbook, and any other source(s) you need to complete this task. Pick any system you want to do your report on. Write your paper fulfilling the requirements listed below. C. Requirements: ---Do this assignment on a 2000 or newer car or truck, with or without Traction Control. Do only the following below that apply to your vehicle. ---Typed, double-spaced, correct grammar, and do not right justify, left justify. Write your paper with the following headings listed below. For example type 1, 2, 3, etc..... The headings make nice transitions for easy reading. ---Do not type in all capital letters. Put in two spaces after a period. ---Type in 12 point font. ---Write your paper with a Title Page that includes D1 and D2. D. Report: 1. Describe make, model, engine size, 2WD or 4WD, and year of your vehicle 2. Manufacturer of ABS system 3. Description of system 4. Number of ABS channels --- 1,3, or 4 5. Explanation of warning light(s) 7. Testing of system 8. How to access data trouble codes (DTC) a. Print off a list of possible ABS data trouble codes (DTC) and insert this into your report. 9. How to clear codes 10. Location for the ABS diagnostic connector DLC for the scanner 11. Explain how the wheel sensors operate a. sensor design b. location of the speed sensors c. number of speed sensors 12. Draw a picture of the following: with the proper meter, allowable specifications and connections for a PM Generator design a. resistance specification b. ACV test procedure c. how to scope this sensor and a normal pattern d. short to ground test e. Draw a picture of the following: with the proper meter, allowable specifications and connections for a Magnetoresistive design f. How many volts are sent to this sensor? g. How many amps does this sensor use? h. How is this sensor tested? 13. How much Bias voltage is sent to each WSS and why? 14. How is the tone/reluctor wheel replaced 15. Is the air gap adjustable 16. Explain how to bleed the system and the sequence 17. State the name of the ABS computer 18. Explain where the anti-lock computer is located 19. Draw out the wiring diagram of system 20. Print out of torque specifications 21. Write out the directions for replacing the front brake pads on a Hybrid vehicle (any Hybrid vehicle of your choice) 22. Bibliography 3pts. Directory: oconnor oconnor -> Updating the Seismic Design Process of Bridges Using Bridge Specific Fragility Analysis oconnor -> Dave O’Connor Jeff Michaels Download 11.8 Kb. Share with your friends:
|