2section (Continued) 6 Layer 3 Processing


Processing of Reverse Traffic Channel Handoff Messages



Download 3.74 Mb.
Page52/61
Date19.10.2016
Size3.74 Mb.
#3566
1   ...   48   49   50   51   52   53   54   55   ...   61
2.6.6.2.5.2 Processing of Reverse Traffic Channel Handoff Messages

The mobile station sends the following messages on the Reverse Traffic Channel in support of handoff when its transmitter is enabled, following the receipt of a forward dedicated channel acquired indication from Layer 2 (see [4]):

1. Pilot Strength Measurement Message or Extended Pilot Strength Measurement Message: The mobile station shall send an autonomous Pilot Strength Measurement Message if P_REV_IN_USEs is less than seven or Extended Pilot Strength Measurement Message if P_REV_IN_USEs is equal to or greater than seven in assured mode. The mobile station shall send either Pilot Strength Measurement Message or Extended Pilot Strength Measurement Message containing measurements consistent with the event whenever any of the following events occur:

• P_REV_IN_USEs is less than or equal to three or SOFT_SLOPEs is equal to ‘000000’ and the strength of a Neighbor Set or Remaining Set pilot is found to be above T_ADDs.

• P_REV_IN_USEs is greater than three, SOFT_SLOPEs is not equal to ‘000000’, and the strength PS, as specified in 2.6.6.2.2, of any Candidate Set pilot is found to satisfy the following inequality:



where the summation is performed over all pilots currently in the Active Set and a Pilot Strength Measurement Message or an Extended Pilot Strength Measurement Message carrying this information has not been sent since the last Extended Handoff Direction Message, General Handoff Direction Message or Universal Handoff Direction Message was received.

• P_REV_IN_USEs is greater than three, SOFT_SLOPEs is not equal to ‘000000’, and the strength PS, as specified in 2.6.6.2.2, of any Neighbor Set or Remaining Set pilot is found to satisfy the following inequality:

where the summation is performed over all pilots currently in the Active Set.

• P_REV_IN_USEs is less than or equal to three or SOFT_SLOPEs is equal to ‘000000’, the strength of a Candidate Set pilot exceeds the strength of an Active Set pilot by T_COMPs  0.5 dB, and a Pilot Strength Measurement Message carrying this information has not been sent since the last Extended Handoff Direction Message, General Handoff Direction Message or Universal Handoff Direction Message was received.

• P_REV_IN_USEs is greater than three, SOFT_SLOPEs is not equal to ‘000000’, and the strength of a Candidate Set pilot exceeds the strength of an Active Set pilot by T_COMPs  0.5 dB and satisfies the following inequality:

where the summation is performed over all pilots currently in the Active Set and a Pilot Strength Measurement Message or an Extended Pilot Strength Measurement Message carrying this information has not been sent since the last Extended Handoff Direction Message, General Handoff Direction Message or Universal Handoff Direction Message was received.

• The handoff drop timer of an Active Set pilot has expired and a Pilot Strength Measurement Message or an Extended Pilot Strength Measurement Message carrying this information has not been sent since the last Extended Handoff Direction Message, General Handoff Direction Message, or Universal handoff Direction Message was received.

• A Candidate Set pilot has been autonomously promoted to the Active Set (see 2.6.6.2.6.1), and an Extended Pilot Strength Measurement Message carrying this information has not been sent since the last Extended Handoff Direction Message, General Handoff Direction Message, or Universal Handoff Direction Message was received.

2. Handoff Completion Message or Extended Handoff Completion Message: The mobile station shall send a Handoff Completion Message if P_REV_IN_USEs is less than seven or an Extended Handoff Completion Message if P_REV_IN_USEs is equal to or greater than seven in assured mode as follows:

• If the handoff message (Extended Handoff Direction Message, General Handoff Direction Message or Universal Handoff Direction Message) specifies a soft handoff, the mobile station shall send the Handoff Completion Message if P_REV_IN_USEs is less than seven or an Extended Handoff Completion Message if P_REV_IN_USEs is equal to or greater than seven within T56m seconds after the action time of the received handoff message.

• If the handoff message (Extended Handoff Direction Message, General Handoff Direction Message or Universal Handoff Direction Message) specifies a hard handoff without return on failure (see 2.6.6.2.8.1), the mobile station shall send the Handoff Completion Message if P_REV_IN_USEs is less than seven or an Extended Handoff Completion Message if P_REV_IN_USEs is equal to or greater than seven within T73m seconds after the action time of the received handoff message.

• If the handoff message (General Handoff Direction Message or Universal Handoff Direction Message) specifies a hard handoff with return on failure (see 2.6.6.2.8.2), the mobile station shall send the Handoff Completion Message if P_REV_IN_USEs is less than seven or an Extended Handoff Completion Message if P_REV_IN_USEs is equal to or greater than seven within T56m seconds after mobile station declares the handoff to be successful (see 2.6.6.2.8.2).

3. Candidate Frequency Search Report Message: The mobile station shall send a Candidate Frequency Search Report Message in assured mode, whenever any of the following events occur:

• RETURN_IF_HANDOFF_FAILs is equal to ‘1’, and a handoff attempt is unsuccessful (see 2.6.6.2.8.2). In this case, the mobile station shall send a Candidate Frequency Search Report Message within T56m seconds after completing a search of all pilots in the Candidate Frequency Search Set and resuming the use of the Serving Frequency Active Set (see 2.6.6.2.8.2.1).

• RETURN_IF_HANDOFF_FAILs is equal to ‘1’, an inter-frequency handoff attempt is unsuccessful (see 2.6.6.2.8.2), and PERIODIC_SEARCHs is equal to ‘1’. In this case, the mobile station shall send a Candidate Frequency Search Report Message in a search period if the conditions specified in 2.6.6.2.8.3.2 are met.

• The mobile station receives a Candidate Frequency Search Request Message or a Candidate Frequency Search Control Message with SEARCH_TYPE set to ‘01’. If none of the conditions requiring the mobile station to send a Mobile Station Reject Order is true (see 2.6.6.2.5.1), the mobile station shall send a Candidate Frequency Search Report Message, as described in 2.6.6.2.8.3.1 and 2.6.6.2.10.1.

• The mobile station receives a Candidate Frequency Search Request Message or Candidate Frequency Search Control Message with SEARCH_TYPE set to ‘11’, SEARCH_MODEs is equal to ‘0000’ and the Candidate Frequency Search Set is not empty. If none of the conditions requiring the mobile station to send a Mobile Station Reject Order is true (see 2.6.6.2.5.1), the mobile station shall send a Candidate Frequency Search Report Message in a search period if the conditions specified in 2.6.6.2.8.3.2 are met.

4. Periodic Pilot Strength Measurement Message: The mobile station shall send a Periodic Pilot Strength Measurement Message in unassured mode, as specified in 2.6.6.2.5.1 and 2.6.6.2.12.

5. Pilot Strength Measurement Mini Message: If the mobile station supports the Mobile Assisted Burst operation capability, the mobile station shall send this message while processing any Supplemental Channel, according to the following:

• The mobile station shall transmit a Pilot Strength Measurement Mini Message for a pilot p in the Active Set on the r-dsch logical channel whenever all of the following conditions are true:



    – ORDER_FLAGs is equal to ‘1’.

    – The pilot p in the Active Set has a received signal strength that is greater than the signal strength of another pilot in the Active Set by PS_MIN_DELTAs, in units of 0.5 dB, at the current time and has been for ORDER_INTERVALs most recent successive 20 ms frame intervals since this pilot was last reported in a rank order based Pilot Strength Measurement Mini Message.

    – The rank order of pilot p has changed.

    • If PERIODIC_FLAGs is equal to ‘1’, the mobile station shall transmit a Pilot Strength Measurement Mini Message within PERIODIC_INTERVALs 20 ms frame intervals on the r-dsch for each of the n pilots in the Active Set with the largest signal strengths, where n = (min (NUM_PILOTS, the number of pilots in the Active Set)), whenever the following condition is true:



– The mobile station has not transmitted another Pilot Strength Measurement Mini Message for the corresponding pilot during the last PERIODIC_INTERVALs 20 ms frame intervals.

• If THRESHOLD_FLAGs is equal to ‘1’, the mobile station shall transmit a Pilot Strength Measurement Mini Message for pilot p on the r-dsch logical channel whenever all of the following conditions are true:

– The mobile station has not transmitted a previous Pilot Strength Measurement Mini Message for pilot p within the most recent THRESHOLD_INTERVALs 20 ms frames intervals.

– Pilot p is in the Active Set.



    The signal strength of pilot p is greater than PS_CEILING_HIGHs and the signal strength of pilot p was less than or equal to PS_CEILING_LOWs at any time since the mobile station last sent a Pilot Strength Measurement Mini Message for pilot p; or the signal strength of pilot p is less than PS_FLOOR_LOWs and the signal strength for pilot p was greater than or equal to PS_FLOOR_HIGHs at any time since the last time that the mobile station sent a Pilot Strength Measurement Mini Message for pilot p.


Download 3.74 Mb.

Share with your friends:
1   ...   48   49   50   51   52   53   54   55   ...   61




The database is protected by copyright ©ininet.org 2024
send message

    Main page