Department of automobile engineering


Figure 31 LUBRICATION SYSTEM



Download 7.64 Mb.
Page40/43
Date19.05.2018
Size7.64 Mb.
#49122
1   ...   35   36   37   38   39   40   41   42   43

Figure 31 LUBRICATION SYSTEM

When an engine is rebait the oil pan is remove cleaned oil passage in the crankshaft cylinder block are cleaned out clean oil passage with wire brush.




  • Park the vehicle on a level surface turn the engine off.

  • Wait a couple of minute for the oil to drain back down into the oil pan

  • With draw the dipstick wipe it clean.

  • Reinset it & with draw it again.

  • Note the oil level on the dipstick the morning on dipstick indicate it oil should be added.

  • Note the condition of the oil to determine it is dirty thick or thin.

  • Rub a few drops of oil between your thumb finger to detect particles.

  • Small the oil to determine it condion gasoline.

  • If the oil level is low add oil. It the oil is contaminated change it.


Why it is necessary to change the oil.




Download 7.64 Mb.

Share with your friends:
1   ...   35   36   37   38   39   40   41   42   43




The database is protected by copyright ©ininet.org 2024
send message

    Main page