For PI Server v3.3 and higher, the following example demonstrates how to edit the PI Trust table:
C:\PI\adm> piconfig @table pitrust @mode create @istr Trust,IPAddr,NetMask,PIUser a_trust_name,192.168.100.11,255.255.255.255,piadmin @quit For the above,
Trust: An arbitrary name for the trust table entry; in the above example,
a_trust_name IPAddr: the IP Address of the computer running the Interface; in the above example,
192.168.100.11 NetMask: the network mask; 255.255.255.255 specifies an exact match with IPAddr PIUser: the PI user the Interface to be entrusted as; piadmin is usually an appropriate user
Security Configuring using Trust Editor
The Trust Editor plug-in for PI System Management Tools 3.x may also be used to edit the PI Trust table.
See the PI System Management chapter in the PI Server manual for more details on security configuration.
PI Server v3.2
For PI Server v3.2, the following example demonstrates how to edit the PI Proxy table:
C:\PI\adm> piconfig @table pi_gen,piproxy @mode create @istr host,proxyaccount piapimachine,piadmin @quit In place of piapimachine, put the name of the PI Interface node as it is seen by PI Server.
This section describes starting and stopping the interface once it has been installed as a service. See the UniInt Interface User Manual to run the interface interactively.
