Sip firmware Release 1 for ip phone 1140e administration

76
Upgrade and convert the IP Phone E firmware
5
Press the gray arrow at the end of the Knowledge and Solution
Engine box to obtain the Search Results.
6
From the Search Results, select the appropriate version of the SIP
Firmware for the IP Phone E, for example, IP Phone 1140E
Release 0625C1HD26.bin.
7
Place the selected firmware on the provisioning server.
—End—
Follow the next procedure to convert the UNIStim Firmware to SIP Firmware on the IP Phone 1140E.
Procedure 12
Converting UNIStim Firmware to SIP Firmware using TFTP
Step
Action
1
Run the TFTP server (for example Tftpd32.exe).
2
Place firmware and configuration files in the folder of the TFTP
server (for example 1140e.img F/W file and 1140e.cfg file) that contains the following lines:
Table 14
Sample 1140e.cfg configuration file
[FW]
DOWNLOAD_MODE AUTO
VERSION 06C25D26.bin
FILENAME 1140e.img
3
Configure the IP Phone E Device Settings TFTP IP address to the IP address where your TFTP server is running.
After you are finished the configuration, the IP Phone reboots and sends a request to the TFTP server.
4
Select the Apply&Reset Context-sensitive soft key to save the settings and reset the IP Phone 1140E.
The following messages display on the IP Phone E as the IP
Phone E cycles through the conversion process, one after the other. [FW] Reading. [FW] Writing...
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

Convert UNIStim Firmware to SIP Firmware on the IP Phone 1140E
77
3. [FW] Finished...
The IP Phone E then boots up with SIP Firmware.
If the conversion is unsuccessful, seethe chapter "Maintenance and troubleshooting" (page 123)
1. TFTP file transfer takes approximately 15 seconds. File writing takes 2.5 minutes. The IP Phone E displays the message [FW] writing
…
and the blue Data Waiting LED flashes. After the new SIP Firmware writing is finished, the blue LED stops flashing and the telephone displays [FW] finished and then reboots. The first time the SIP Firmware boots, the SIP Firmware performs a Flash File System conversion that takes 2.5 minutes.
—End—
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

78
Upgrade and convert the IP Phone E firmware
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks