Sip firmware Release 1 for ip phone 1140e administration

If you are using DHCP, select Full or Partial. If you are manually configuring the IP address, netmask, and gateway address, selectNo.4

Download 1.47 Mb.

View original pdf

Page	47/76
Date	14.08.2023
Size	1.47 Mb.
	#61855

1 ... 43 44 45 46 47 48 49 50 ... 76

NN43113-300 02.05 1140E Adm

[FW] finished.

3
If you are using DHCP, select Full or Partial. If you are manually configuring the IP address, netmask, and gateway address, select
No.
4
If the DHCP option is set to Full or Partial, the IP address is automatically obtained.
5
Configure the TFTP IP address within the IP Phone E Device
Settings menu.
This can be the provisioning server as defined in the chapter "Configure the provisioning server" (page 25)
6
Select the Apply&Reset Context-sensitive soft key to save the settings and reset the IP Phone 1140E.
The IP Phone E downloads the firmware file. The display shows [FW] reading
…
If the download is successful, the display shows [FW] writing
…
and the blue LED flashes.
After the firmware image is downloaded to the IP Phone E, the display shows [FW] finished. the blue LED stops flashing, and the
IP Phone E resets.
SIP Firmware Release 1.1 for IP Phone E Administration
NN43113-300 Standard May Copyright © 2008, Nortel Networks

Convert UNIStim Firmware to SIP Firmware on the IP Phone 1140E
75
If the upgrade is unsuccessful, seethe chapter "Maintenance and troubleshooting" (page in the section Download failures.
—End—
Convert UNIStim Firmware to SIP Firmware on the IP Phone 1140E
The IP Phone E can be ordered with UNIStim Firmware installed or with SIP Firmware installed. If an IP Phone E is installed with UNIStim
Firmware, it runs with SIP Firmware only if the firmware is converted from
UNIStim to SIP. If the procedure to determine the UNIStim version number is complete, and, if necessary, the procedure to upgrade the UNIStim
Firmware is complete, an IP Phone E can be converted from UNIStim
Firmware to SIP Firmware.
Compare the version number to the minimum required UNIStim Firmware version (0625C1H).
UNIStim Firmware version names contain numbers and letters. Use the last three characters in aversion to compare the version of UNIStim on an IP Phone E (0625C1H) with the minimum required version for the upgrade. Note that C is greater than C1H and CB is less than C1H.
The conversion must be performed using TFTP.
WARNING
The TFTP download and upgrade of the Flash memory on the
IP Phone E may take a significant amount of time (possibly up to 10 minutes. Do not unplug or reboot the IP Phone 1140E
during the process.
The next procedure explains how to download the SIP Firmware from the
Nortel Web site.

Download 1.47 Mb.

Share with your friends:

1 ... 43 44 45 46 47 48 49 50 ... 76