Step 2: Establish an SSH connection from PC-C to R3

Step 2: Establish an SSH connection from PC-C to R3.

1. 
   Start PuTTy or another SSH client, and log in with the admin account and password cisco12345 created when AutoSecure was run. Enter the IP address of the R3 G0/1 interface 192.168.3.1.
   
2. 
   Because SSH was configured using AutoSecure on R3, you will receive a PuTTY security warning. Click
   

3. 
   Enter privileged EXEC mode, and verify the R3 configuration using the show run command.
   
4. 
   Issue the show flash command. Is there a file that might be related to AutoSecure, and if so what is its name and when was it created?
   

5. 
   Issue the command more flash:pre_autosec.cfg. What are the contents of this file, and what is its purpose?
   

6. 
   How would you restore this file if AutoSecure did not produce the desired results?