T-1849 target atlantic terminal summary

T-1849 ATLANTIC TERMINAL

13. 
    Replace the right side wheel inlet guide due to wear. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Replace the left side wheel inlet guide due to wear. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Replace the pillow block bearing on the drive shaft between the brake and the drive belt.
    Completed ________________ Initialed ___________
    

13. 
    Bottom main junction box in bottom access panel is loose. Missing a bolt. Provide and secure bolt.
    Completed ________________ Initialed ___________
    

13. 
    Chains are over 2 ½” off. Getting faults. Replace chains. May try removing several links but these have been shortened once already.
    Completed ________________ Initialed ___________
    

13. 
    Replace 2 broken cones on the left side.
    Completed ________________ Initialed ___________
    

13. 
    Replace 11 broken cones on the right side. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Replace the top left wheel inlet guide due to extreme wear on the front part of the wedge. Ready to open up or wear through. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Replace the top right wheel inlet guide due to extreme wear on the front part of the wedge. Ready to open up or wear through. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Replace the top end stop button cover, broke in half. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    Clean the machine space of all debris, purple threads and dirt. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

13. 
    The fault code device on the bottom end does not display. Repair or replace. REPEAT REQUEST
    Completed ________________ Initialed ___________
    

1. 
   Install elevator ID tactile at all landings.
   

1. 
   Clean the floor on the other side of the first access door to the machine room. Getting very nasty and starting to track it onto the store when the techs go in and out.
   

2. 
   Install elevator ID tactile at all landings.
   

1. 
   Install elevator ID tactile at all landings.
   

2. 
   There are two roof hatches in the top floor where access is through the Target space of stairwell C. Although they are above the stairwell, stairs could be made to access the roof about 25 feet to the North of the machine room of Elevators 7,8,9. Would be safer and more convenient for machine room access and probably the most cost effective way to resolve the problematic roof access issue.
   

1. 
   There is a ¾ inch wide by 8” long gap between the top Vermaport landing plate and the Down Escalator plate. Fill it in with a foam bead and caulk.