Document submitted to



Download 182.84 Kb.
Page1/6
Date30.05.2017
Size182.84 Kb.
#19504
  1   2   3   4   5   6

Telecommunications Industry Association

TR-30.3/10-12-0273

(TIA)










TBD Austin, TX December 6-8, 2010





DOCUMENT SUBMITTED TO

TR-30.3 Meeting


The document to which this cover statement is attached is submitted to a Formulating Group or sub-element thereof of the Telecommunications Industry Association (TIA) in accordance with the provisions of Sections 6.4.1-6.4.6 inclusive of the TIA Engineering Manual dated October 2009, all of which provisions are hereby incorporated by reference.


SOURCE: Editor, TIA-921-B
CONTACT: Ed Schulz
LSI Corporation
1110 American Pkwy NE
Allentown, PA 18109
610-712-2068

Ed.Schulz@lsi.com


TITLE: Proposed Outline and New Text for TIA-921-B
PROJECT: PN-3-0062-RV2
DISTRIBUTION: Members of TR-30.3


INTENDED PURPOSE OF DOCUMENT:

_X_

FOR INCORPORATION INTO A TIA PUBLICATION

____

FOR INFORMATION ONLY

____

OTHER (please describe):


____________________
ABSTRACT
Rather than edit the draft TIA-921-B standard in place, it might be easier to review each proposed section on its own, or held beside the original document. The proposed outline and text are suggested by the existing TIA-921-A, and by presentations and discussions in TR-30.3 over the past few years. This text has been edited heavily during the August, 2010 and September, 2010 meetings.


Table of Contents




Foreword


(This foreword is not part of this Standard.)
ANSI-accredited committee TR-30.3 has developed this TIA-921-B Standard, which defines an IP network model. This model, along with the specified scenarios, are intended for evaluating and comparing communications equipment connected over a converged network.

Building upon the experience of creating network nodels, TR-30.3 Subcommittee has created this Network Model for IP Impairments using the similar methodology developed in its previous standards and bulletins:



EIA/TIA-496-A-1989: Interface Between Data Circuit Terminating Equipment (DCE) and the Public Switched Telephone Network, which includes a Network Model for Evaluating Modem Performance

TIA TSB-37-A-1994: Telephone Network Transmission Model for Evaluating Analog Modem Performance, which became ITU-T Recommendation V.56bis-1995

TIA TSB-38-1994 (and TSB-38-A -2007): Test Procedures for Evaluation of 2-Wire 4 Kilohertz Voice Band Duplex Modems, which became ITU-T Recommendation V.56ter-1996

ANSI/TIA/EIA-3700-1999: Telephone Network Transmission Model for Evaluating Analog Modem Performance

ANSI/TIA/EIA-793-2001: North American Telephone Network Transmission Model for Evaluating Analog Client and Digitally Connected Server Modems

ANSI/TIA-876-2002: North American Network Access Transmission Model for Evaluating xDSL Modem Performance
TIA-921-B was approved on [insert date]. It cancels and replaces TIA-921-A (2008) in its entirety. Technical changes from TIA-921-A include:

TIA-921-B models the mechanisms that contribute to packet delay, jitter, and loss: interfering streams, queueing delays in network elements, and the characteristics of specific access technologies. The intent is to provide more realism than the earlier version. TIA-921-A defined a mathematical model that fit certain observed network behavior, but was not easily extended to other scenarios.

The “likelihood of occurrence” concept is no longer applied to IP networks.

TIA-921-B is a true bidrectional model.

Impairment levels are updated to keep current with evolving IP networks.

The number of standard test cases is greatly reduced.

Users can customize test cases to fit their specific needs.
There are [insert number] of6 Annexes in this Standard. Annexes A, B, C, and D [and Annex B] are normative and are considered part of this Standard. Normative Annexes B, C, and D include electronic attachments. Annexes E and F [C and Annex D] are informative and are not considered part of this Standard. [Annexes X, Y, Z are provided electronically, rather than in print.]


Introduction

TIA-921-B describes a model of Internet Protocol (IP) networks for the purpose of evaluating the performance of IP streams. The focus is on packet delay, delay variation, and loss. IP streams from any type of network device can be evaluated using this model.


Emphasis is given to the fact that manufacturers of communications equipment and service providers are interested in a specification that accurately models the IP network characteristics that determine performance. Evaluators desire a definitive set of simple tests that properly measure the performance of communications devices from various manufacturers. Therefore, the objective of this standard is to define an application-independent model (e.g. data, voice, voiceband data, and video) that is representative of IP networks, that can be simulated at reasonable complexity, and that facilitates practical evaluation times. The IP network model presented herein represents a snapshot of actual network data provided by anonymous IP service providers and IP network equipment manufacturers in the 2010 timeframe, and will continue to evolve as more statistical information becomes available and as the IP network evolves.
Network Model for Evaluating Multimedia Transmission Performance Over Internet Protocol


Download 182.84 Kb.

Share with your friends:
  1   2   3   4   5   6




The database is protected by copyright ©ininet.org 2024
send message

    Main page