Department of automobile engineering

• 
  Drain the cooling system to blow of the cooling outlet connection.
  
• 
  Remove the coolant outlet connection retaning belts slide the connection with the hose attached to one side.
  

• 
  Remove the thermostat gasket. Drain the cooling system to blow of the cooling outlet connection.
  
• 
  Remove the coolant outlet connection retaning belts slide the connection with the hose attached to one side.
  
• 
  Remove the thermostat gasket.
  

Place the thermostat in a container water heat the water it the thermostat valve does not opening temperature or if fail to close install a new thermostat.

• 
  Clean the coolant outlet connection cylinders head surface coat a new coolant outlet the gasket with sealer position the gasket on cylinder head.
  
• 
  Coat the edge of the thermostat with grease so it stick in the water outlet connection.
  
• 
  Position the thermostat in the recess of the water outlet connection so that heat element will be the cylinder head.
  
• 
  Position the water outlet connection install the retain bolts be carefully not to disturb the thermostat.
  
• 
  Fill the radiator + operate the engine check for coolant leaks.Drain the cooling system to blow of the cooling outlet connection.
  
• 
  Remove the coolant outlet connection retaning belts slide the connection with the hose attached to one side.
  
• 
  Remove the thermostat gasket.
  

• 
  Servicing of pressure feed pump
  
• 
  Checking and inspection of splash cup
  
• 
  Method of replacing lubricating oil
  

The two most common complain related to the lubricating system are.

• 
  Engine use too much oil
  
• 
  The oil pressure light or gauge show low oil pressure.