|
-2 APU Instrumentation
|
| Page | 40/43 | | Date | 20.10.2016 | | Size | 2.65 Mb. | | #6810 |
| 10-2 |
|
|
|
|
|
|
1)
|
Revolutions Per Minute (RPM)/ Exhaust Gas Temperature (EGT) Indicators (T62T-40C8D/ T62T-40C8D1 and 36-150/92/100/ APU Only)
|
C
|
2
|
0
|
May be inoperative provided APU is not used.
|
|
|
2)
|
Ampere (Amp) Meter/Load Meter
|
C
|
1
|
0
|
May be inoperative provided APU is not used.
|
|
| 30-2
***
| APU Operating Cycle Recorder |
C
|
1
|
0
|
(O) May be inoperative provided an alternate procedure for recording APU operating cycles is established and used.
|
|
Record APU cycles used in APU logbook.
|
Maintenance and Operational Procedures
for Federal Aviation Administration Master Minimum Equipment List - No: 8c 10/17/2012
|
1. SYSTEM,
Sequence Numbers & Item
|
Repair Category
|
|
2. Number Installed
|
|
|
3. Number Required for Dispatch
|
MAINTENANCE
PROCEDURES
|
OPERATIONAL
PROCEDURES
| 52 – DOORS |
|
|
|
4. Remarks and Exceptions
| 11-1 | Main Entry Door Unlock Indication System |
C
|
1
|
0
|
(O) May be inoperative provided door is both visually and manually verified to be fully closed and locked before each departure.
|
|
Prior to each departure, close and lock door and visually confirm the handle is in the locked position and that each (6) lock is seated.
| 25-1 | Rear Baggage Pannier/External Baggage Compartment (EBC) Door Unlock Indications |
C
|
-
|
0
|
(O) May be inoperative OFF provided door(s) is/are visually and manually verified fully closed and locked before each departure.
|
| -
Prior to each departure,
-
Open Left Hand (LH) Pannier Door,
-
Operate latching handle checking for extension and retraction of all three (3) latching pins, and
-
Close and latch door.
-
Repeat above bulleted steps for Right Hand (RH) Pannier Door (if installed).
|
|
|
C
|
-
|
0
|
(M) (O) May be inoperative ON provided:
-
System is deactivated, and
-
Door(s) is visually and manually verified fully closed and locked before each departure.
| -
Gain access to Connectors ‘UL’ and UK’ through Access Panel F162 behind Baggage Pannier.
-
Remove wires ‘K’ and ‘V’ from both connectors, cap, and stow.
-
Check that indication is OFF.
| -
Prior to each departure, perform the following:
-
Open LH Pannier Door,
-
Operate latching handle checking for extension and retraction of all three (3) latching pins, and
-
Close and latch door, and
-
Repeat above bulleted steps for RH Pannier Door (if installed).
| | | Series 750 |
C
|
-
|
0
|
(M) (O) May be inoperative ON provided:
-
System is deactivated, and
-
Door is visually and manually verified fully closed and locked before each departure.
| -
Gain access to Connector ‘UZ’ through Access Panel F162 behind Baggage Pannier.
-
Remove wires ‘K’ and ‘V’ from connector, cap, and stow.
-
Check that indication is OFF.
| -
Prior to each departure, perform the following:
-
Open LH Pannier Door,
-
Operate all latches checking for extension and retraction of latching pins, and
-
Close and latch door.
| | |
Share with your friends: |
|
|
