May – June 2020 ISSN: 0193-4120 Page No. 16434 – 16444 16442
Published by The Mattingley Publishing Co, Inc. V. TESTING AND RESULTS The software is capable of performing numerous tests for the simulated motor. But there are two tests that are noteworthy and carry the maximum girth towards the impact on the efficiency of the motor. Running these two tests resolves issues, gives an overall outlook and provides an aspiring report database for further inclinations.
A. Machine Performance Test In this test, the machine performance is rated using the torque ranged at 440Nm.
in this test, the machine is rated by the performance in the mediocre range. This means that the system runs on neither full nor negligible capacity. This test
Fig. 6. Flux Density distribution over Radial View is very important to understand the machine characteristics and its operation on constant and long working hours. The test results shown in Figure 8 show the different outputs and consumption values. The values of the output torque for rated speed, line current and mechanical power are illustrated in the figure. The testis also characterised
by the Mechanical torque curve, a line to line voltage with time curve and one of the most important, and the flux density curve. The graphs scene in Figure 9, 10 and 11 show that A) The torque is effectively controlled using the control angle (firing angle) and does not shown any uneasy ripples. B)
In an open circuit, the line to line voltage is undeterred and can be seen with only a few ripples real time simulation.
Share with your friends: 
